Steel Plywood Forming System Snap Tie Wedge and Jahn A/C Bracket

Product Introduction:

Steel Plywood Forming System Snap Tie Wedge and Jahn A/C Bracket. Wedge pins are used with flat tie to tighten adjoining concrete forms, securing the flat tie and concrete form in place. The full set of the Symons Formwork Accessories including the Wedge Bolt, Long Bolt, Short Bolt, X-Flat Tie, One Piece Waler Clamp, Z Tie Holders & Waler Tie, J-Strongback Hooks and Strongback Ties, Scaffold Brackets and Turnbuckles.

Parameters

Product Introduction:

PRODUCT DETAILS

Steel Plywood Forming System Snap Tie Wedge

The snap tie wedge is a holding device that is fabricated from high strength galvanized steel that is used in a double waler or double strong back snap tie forming application to ensure proper load distribution when installed correctly. The snap tie wedge acts as a tie holder that slides vertically down the tie just inside the tie head drawing up all of the form components until snug. Horizontal double walers and/or vertical double strongbacks must be positioned within 5/8” – ¾” of either side of the Tie and the snap tie wedge must bear evenly. The tie end must end up at the midpoint of the wedge or slightly higher.

Snap Tie Wedge	Picture	Surface treatment	Weight	Packaging
		silver galvanized	180g	100pcs/carton
		silver galvanized	210g	100pcs/carton
		blue painting	250g	100pcs/carton
A bracket		galvanized and painting	570g	25pcs/carton
C bracket		galvanized and painting	437g	25pcs/carton