The emergence of a new type of water stop rod compensates for the shortcomings of traditional water stop rod technology. It is a new type of wall water stop rod with reasonable design, simple structure, high resistance to tension and pressure, good water seepage and environmental protection performance, and convenient installation and disassembly.

The disadvantages of traditional water stop pull rods are: 1. It is difficult to check and ensure the quality of the weld seam, and it is passive waterproof. Once there are defects such as cracks, slag inclusion, burning through, strong pores, and missed welding in the weld seam, it is easy to create a water seepage path and difficult to cure.

2. If the concrete strength does not meet a certain requirement, the formwork will be removed in advance, causing the tension rod to rotate. It may also be due to the lack of anti-seepage treatment on the outer side of the tension rod after the external wall formwork is removed, resulting in leakage.

3. After the concrete pouring is completed, not only are the screws unable to be removed, but the screw template protruding from the outside of the wall is difficult to disassemble and needs to be cut by gas cutting. Moreover, the wall treatment after cutting is difficult, wasting a large amount of steel and increasing construction costs.

What is the function of a new type of water stop rod in construction? The water stop rod belongs to the water stop component used for fixing the wall of the cast-in-place horizontal plate in the basement. It includes a rod body, a water stop plate fixed in the middle of the rod body, which is a middle rod component with a length equal to the thickness of the cast-in-place cement wall. The two ends of the middle rod are respectively fixed with connecting nuts; There is also a left rod component: the inner end of the left rod is equipped with a thread for screwing in with the connecting nut, the outer end of the left rod is equipped with a thread, and the screwing in is equipped with a nut, as well as a pressure block and gasket in the ring; It also has a right rod component with the same structure as the left rod component. After the wall pouring construction, the left and right poles can be removed from the middle pole and reused. It has the advantages of saving materials, energy, and flat construction walls.